Installation Instructions
TOWN SQUARE
ACRYLIC SHOWER BASE
Certified to comply with ANSI Z124.2 1987.
Observe local plumbing and building codes.
MODELS 3636.STTS, 3838.NEOTS, 4834.STTS
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years.To ensure this product is
installed properly, please read these instructions carefully before you begin. (Certain installations may require professional
help.) Also be sure your installation conforms to local codes.
For alcove (.STTS models) installation only:
The opening dimensions should be 1/8" larger than dimensions shown.
752769-100 Rev. C
NOTE: Read instructions completely before proceeding with installation.
3838.NEOTS
3636.STTS
4834.STTS
484mm
(19-1/16)
FRONT
FRONT
679mm
(26-3/4)
870mm
(34-1/4)
914mm
(36)
972mm
(38-1/4)
215mm
(8-7/16)
215mm
(8-7/16)
484mm
(19-1/16)
215mm
(8-7/16)
610mm
(24)
457mm
(18)
1219mm
(48)
914mm
(36)
215mm
(8-7/16)
972mm
(38-1/4)
DRAIN
ASSEMBLY
2
1
3838 NEOTS
Strainer
Before installing drain into
the shower base, remove
strainer (see Fig. C). This
will be installed after
Rubber
Caulking
Gasket
Insure the floor and stud walls
are square and plumb.
Provide a 5" x 5" (127mm x
127mm) opening in the floor
for the drain (see Figs. A & B).
The drain plug accommodates
a 2" (51mm) PVC waste pipe.
The waste pipe should extend
above the surface of the
Drain
Body
shower base is in its final
position. Install the drain to
the shower base as shown
in Fig. D. Use silicone
sealant between drain
body and shower base.
Silicone
Sealant
C/L
Shower
Base
C/L
90°
90°
51 mm (2)
PVC Waste Pipe
127mm x 127mm
(5 x 5) Opening
Rubber
Gasket
Fiber
Gasket
sub-floor 3/8" 1/16".
(See Product Chart for Drain Location)
A
Locking
Nut
Note: Variations in levelness
of subfloor may require
adjustment of waste pipe
height. See product drawings
on this page for the specified
drain locations.
C
3636.STTS, 4834.STTS
Waterproof
Drywall
13mm (1/2")
minimum
3 mm
(1/8)
No Bedding
Under
Apron
Bedding Material Area
90°
90°
51 mm (2)
127mm x 127mm
(5 x 5) Opening
C/L
51 mm (2)
PVC Pipe
PVC Waste Pipe
Bedding
Material
51 x 102 mm
(2 x 4) Stud Wall
(See Product Chart for Drain Location)
B
127 mm (5)
D
|